Makita HM1202C Specifications download pdf (Page 10)

Use a screwdriver to remove the brush holder caps. Take out

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

Lubrication

This tool requires no hourly or daily lubrication because it

has a grease-packed lubrication system. It should be relubri-

cated after every 6 months of operation. Send the complete

tool to Makita Authorized or Factory Service Center for this

lubrication service. However, if circumstances require that

you should lubricate it by yourself, proceed as follows.

Run the tool for several minutes to warm it up. Switch off and

unplug the tool.

Loosen the six screws and remove the handle.

Remove the crank cap using a socket wrench. Rest the tool

on the table with the bit end pointing upwards. This will allow

the old grease to collect inside the crank housing.

Wipe out the old grease inside and replace with a fresh

grease (30 g; 1 oz). Use only Makita genuine hammer

grease (optional accessory). Filling with more than the speci-

fied amount of grease (approx. 30 g; 1 oz) can cause faulty

hammering action or tool failure. Fill only with the specified

amount of grease.

Reinstall the crank cap and tighten with the socket wrench.

CAUTION:

• Do not tighten the crank cap excessively. It is made of

resin and is subject to breakage.

• Be careful not to damage the terminals or lead wires

especially when wiping out the old grease or installing

the handle.

1. Screwdriver

2. Brush holder cap

002954

1. Screws

002967

1. Socket wrench

2. Crank cap

002968

1. Hammer grease

002969

1 ... 9 10 11 12 13 14 15 16

No comments

Makita HM1202C Specifications Page 10