Makita 3803A Specifications

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.Groove CutterMODEL 3

10Align the right side of the cutting blade with the cutting line.Move the guide rule until the shiplapping attachment con-tacts the side o

11Dado cutting guide rule (optional accessory)Firmly clamp a straight board to the workpiece parallel to thecutting line and use it as a guide

12Guide ruleThe handy guide rule allows you to make accurate straightcuts parallel to a straight edge of a workpiece. Loosen thewing bo

13ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any othe

Memo14

Memo15

Memo16

17FoldCutStampTimbreMakita Canada Inc.1950 Forbes Street,Whitby, OntarioL1N 7B7

18Your answers to the following questions are appreciated.Date Purchased Model No.Serial No.Initial Last NameStreet AddressCity ProvinceAGE:Male Femal

19Factory Service CentresFor the authorized service centre nearest you please refer to the local yellow pages directory under “tools” or con-tact our

2SPECIFICATIONS•Manufacturer reserves the right to change specifications without notice.•Specifications may differ from country to country.GENERAL SAF

Warranty PolicyEvery Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to be free of defects fromworkmanship

35. Avoid body contact with grounded sur-faces such as pipes, radiators, ranges andrefrigerators. There is an increased risk ofelectric shock if

4SERVICE23. Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcoul

5SPECIFIC SAFETY RULES USB084-1DO NOT let comfort or familiarity with product (gained fromrepeated use) replace strict adherence to gro

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.A

7• When using cutter blades 110 mm (4-3/8”) in diameter,simply re-install the indication plate upside down andadjust it so that it points to th

8Installing or removing cutter bladeTo re move th e c utt er bla d e, lo o se n t he wi ng bo l t an d t ake of fthe cutter cover. Ho

9Side platesThe side plates help to prevent splintering of workpiece. Thistool is equipped with two side plate 21 - 30 (originallyinstalled