Makita 2-SPEED HAMMER 8401 Instruction Manual download pdf (Page 5)

Installing

side

grip (auxiliary handle)

The side grip

an important means of maintaining good control of this hammer drill

during use in the even bit or accessory jams, causing the tool

twist

from your hand with

the potential to cause injury. Loosen the wing nut on the side grip and install the side grip

on the tool. The side grip swings around to either side, allowing easy handling of the tool

in any position. Swing the side grip to the desired position and then tighten the wing nut

to secure the side grip.

Installing

or removing drill bit

CAUTION

Always be sure that the tool

switched off and unplugged before installing or removing

the bit.

To install the bit, place

in the chuck

far

will go. Tighten the chuck by hand.

Place

the chuck key in each of the three

holes and tighten clockwise. Be sure to

tighten

all

three chuck holes evenly.

To remove the bit, turn the chuck key

counterclockwise in just one hole, then

loosen the chuck by hand.

After using the chuck key, be sure to return

to the original position.

Depth

gauge

The depth gauge

convenient

for

drilling

holes of uniform depth. Loosen the wing

bolt and adjust the depth gauge to the de-

sired depth. After adjusting, tighten the

wing bolt to secure the depth gauge.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita 2-SPEED HAMMER 8401 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Makita 2-SPEED HAMMER 8401