Makita XPK01 Use and Care Manual download pdf (Page 10)

Draw a cutting line on the workpiece. Insert the edge

fence into the hole in the front of the tool. Align the blade

edge with the cutting line.

011760

Adjust the edge fence until it comes in contact with the

side of the workpiece, then secure it by tightening the

screw.

011761

When planing, move the tool with the edge fence flush

with the side of the workpiece. Otherwise uneven

planing may result.

Maximum shiplapping (rabbeting) depth is 9 mm

(11/32").

010183

You may wish to add to the length of the fence by

attaching an extra piece of wood. Convenient holes are

provided in the fence for this purpose, and also for

attaching an extension guide (optional accessory).

Chamfering

003634

011748

To make a chamfering cut as shown in the figure, align

the "V" groove in the front base with the edge of the

workpiece and plane it.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and the

battery cartridge is removed before attempting to

perform inspection or maintenance.

• Never use gasoline, benzine, thinner, alcohol or

the like. Discoloration, deformation or cracks may

result.

Sharpening the conventional planer blades

(optional accessory)

002588

Always keep your blades sharp for the best performance

possible. Use the sharpening holder (optional

accessory) to remove nicks and produce a fine edge.

1. Sharpening

holder

1. Screw

2. Edge fence

(optional

accessory)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Comments to this Manuals

No comments

Makita XPK01 Use and Care Manual Page 10

Comments to this Manuals