7
Hold the trimmer with both hands pull the switch trigger
A or B and move it in front of your body.
009315
As a basic operation, tilt the blades towards the
trimming direction and move it calmly and slowly at the
speed rate of 3 - 4 seconds per meter.
009318
1
2
3
009285
To c ut a he dge to p e ve nl y, i t he lps t o ti e a s tr ing a t t he
desired hedge height and to trim along it, using it as a
reference line.
009320
Attaching the chip receiver (accessory) on the tool when
trimming the hedge straight can avoid cut off leaves’
being thrown away.
009321
To c ut a h ed ge s id e e ve nl y, i t he lps t o cu t f ro m th e
bottom upwards.
009322
Trim boxwood or rhododendron from the base toward
the top for a nice appearance and good job.
009323
Installing or removing chip receiver
(accessory)
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing chip
receiver.
NOTE:
• When replacing the chip receiver, always wear
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
• Always be sure to remove the blade cover before
installing the chip receiver.
• The chip receiver receives cut-off leaves and
alleviates collecting thrown-away leaves. This can
be installed on either side of the tool.
1. Trimming
direction
2. Tilt the blades
3. Hedge surface
to be trimmed
Comments to this Manuals