Makita ELECTRIC BRAKE 6094DW Instruction Manual

Equipped with Electric Brake MODEL 6094D MODEL 6094DW With Fast Charger Capacities INSTRUCTION MANUAL Dimensions No load speed SPEC IF I CAT IONS Mod

Wood screws I 3.5 mm x 20 mm (1/8" x 3/4") I ~~~~ 4.5 mm x 20 mm W16' x 3/4") Medium hard wood I 400 screws 90 screws 60 screws 5

MA1 NTENANCE CAUTION : Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or

ACCESSORI ES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any

Dec-19-86 EN CORDLESS SCREWDRIVER Model 60941) Note: The switch and other part configurations may differ from country to country. 13

MODEL 60940 ';"OM $:D DESCRIPTION ~ 26 27 28 29 30 31 32 33 34 35 36 37 36 39 40 41 42 43 44 45 46 47 48 49 Dec.-19-'86 EN AtD DESCRIPT

MAKmA LIMED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to be f

IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFE- TY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO SONAL IN

14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15.

IMPORTANT SAFETY INSTRUCTIONS 1. SAVE THESE INSTRUCTIONS - This manual contains important safety and operating instructions for battery charger. 2.

ADDITIONAL SAFETY RULES FOR CHARGER & BATTERY CARTRIDGE 1. Do not charge Battery Cartridge when temperature is BELOW 10°C (5OOF) or ABOVE 4OoC

Installing or removing battery cartridge 0 Always switch off the tool before insertion or removal of the battery cartridge. *To remove the battery ca

Installing or removing driver bit CAUTION : Always be sure that the tool is switched off and the battery cartridge is removed before installing or r

Reversing switch action This tool has a reversing switch to change the direction of rotation. Slide the revers- ing switch to the right for clockw

Screwdriving operation Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then inc