PRODUCTCONCEPT AND MAIN APPLICATIONSP 1/ 15SpecificationStandard equipmentNote: The standard equipment for the tool shown above may vary by country.Mo
P 10/ 15(2) Check the following points. • Intermediate flange is inserted into the groove on Engine housing complete. • When Cylind
P 11/ 15See Figs. 28 and 29 for the positions of Needle-idle (L) and Needle-high speed (H).Carburetor has two different specifications (Walbro-made a
P 12/ 15Unscrew 5.5x16 Hexalobular tapping screw and pull Grip shell halfslightly up and toward the screw hole side. (Fig. 32) Note: When disassemblin
P 13/ 15(1) Referring to “DISASSEMBLY of [2]-11. Tank assembly”, disassemble the machine as drawn in Figs. 34 and 33.(2) Using long-nose pliers, caref
P 14/ 15(1) Remove “Air filter, Carburetor, and Intermediate flange” as mentioned in [2]-10. (Figs. 22, 23, 24, and 25)(2) Piston set can be separated
[3] TIGHTENING TORQUEFastening forCrank case underside 266608-2 45x40 Hexalobular tapping screw Part No. of Screw/ Bolt/ Clutch Description Quantity F
P 2/ 15[1] NECESSARY REPAIRING TOOLS[2] DISASSM|BLY/ ASSEMBLY[2]-1. Chain tensionerDescriptionCode No. Use forT-type hexalobular wrench (1) Remove Spr
P 3/ 15(1) Remove Sprocket guard, Guide bar and Saw chain from machine.(2) Insert Small-slotted screwdriver into the gap between Crank shaft and Retai
P 4/ 15(1) Remove Sprocket guard, Guide bar and Saw chain from machine.(2) Remove Clutch drum assembly. (Figs. 4 and 5) (3) Turn Hand guard toward Ch
P 5/ 15(1) Remove Sprocket guard, Guide bar and Saw chain from machine.(2) Unscrew M5x40 Hexalobular socket head bolt and two M5x16 Hexalobular socket
P 6/ 15(1) Remove Sprocket guard, Guide bar and Saw chain from machine.(2) Pull Hand guard toward Tubular handle to release Chain brake. Then, remove
P 7/ 15(1) Remove Clutch drum section and Clutch section. Refer to [2]-2 “Clutch drum section” and [2]-5 “Clutch section”. (2) Remove Tension sp
P 8/ 15(1) Remove Sprocket guard, Guide bar and Saw chain from the machine.(2) Remove “Recoil starter section”. See [2]-7 “Recoil starter section”.(3)
P 9/ 15Note: Drain Fuel tank before disassembling Carburetor. See Fig. 22. (1) Remove Hood. (2) Turn Choke lever to the position o
Comments to this Manuals