Makita EM2600U Instruction Manual download pdf (Page 9)

CAUTION: Before doing any work on the brush cutter, always stop the engine

and disconnect the spark plug connector from the spark plug.

Always wear protective gloves!

CAUTION: Ensure you have reassembled the brush cutter completely before

starting it.

For U handle models

– Place the two handles onto the handle holder. The control lever must come

right side when you look towards the cutting tool.

– Fit the handle ends to the groove on the handle holder and fit the clamp on

them. Loosely tighten them with four bolts for adjustment.

– Adjust handles’ angle, and then tighten all bolts evenly by a hex wrench.

– Place the throttle cable (1) to the control lever side of the shaft. And then wrap

them with the waist pad (2).

– Insert the throttle cable (1) into the clamping slot (3) of the handle holder.

– Make sure the throttle cable is positioned as shown.

– Operate the control lever and make sure it moves smoothly.

CAUTION: Do not position the throttle cable as shown. Otherwise curved cable

may cause high idle speed, and uncontrollable blade may cause

personal injury.

Mounting the handle

EM2600U

(1)

EM2600U

(2)

EM2600U

(3)

(1)

EM2600U

1 2 3 4 5 6 7 8 9 10 ... 20

No comments

Makita EM2600U Instruction Manual Page 9