Makita EM2600U Instruction Manual download pdf (Page 19)

– When storing the equipment for a long period of time, drain all the fuel from

the fuel tank and carburetor. To do this, simple drain all of the fuel from the fuel

tank. Dispose of the drained fuel in accordance with local applicable laws.

– Remove the spark plug and add a few drops of oil into the spark plug hole.

Then, pull the starter gently so that oil coats the inside of the engine, then

tighten the spark plug.

– Clean any dirt or dust from the cutter blade and outside of the engine, and

wipe them with a oil-immersed cloth. Store the equipment in a dry place.

Maintenance schedule

Troubleshooting

Storage

General

Engine assembly, screws and nuts

Visual inspection for damage and tightness

Check for general condition and security

After each refuelling Control lever

I-Stop Switch (on/off)/Start-Stop Switch

Functional check

Daily Air filter

Cooling air duct

Cutting tool

Idling speed

To be cleaned

Check for damage and sharpness

Inspection (cutting tool must not move)

Weekly Spark plug

Muffler

Inspection, replace if necessary

Inspect, and clean the opening if necessary

Quarterly Suction head

Fuel tank

To be replaced

To be cleaned

Shutting down procedure Fuel tank

Carburetor

Empty fuel tank

Operate until engine runs out of fuel

Fault System Observation Cause

Engine doesn’t start, or is

difficult to start

Ignition system Ignition spark O.K. Fault in fuel supply or compression system, mechanical

defect

No ignition spark I-Stop Switch (on/off)/Start-Stop Switch operated, wiring

fault or short circuit, spark plug or connector defective,

ignition module faulty

Fuel supply Fuel tank filled Incorrect choke position, carburetor defective, fuel

supply line bent or blocked, fuel dirty

Compression No compression when

pulled over

Cylinder bottom gasket defective, crankshaft seals

damaged, cylinder or piston rings defective or improper

sealing of spark plug

Mechanical fault Starter not engaging Broken starter spring, broken parts inside the engine

Warm start problems Tank filled. Ignition spark

O.K.

Carburetor contaminated, must be cleaned

Engine starts but dies Fuel supply Tank filled Incorrect idling adjustment, carburetor contaminated

Fuel tank vent defective, fuel supply line interrupted,

cable or I-Stop Switch (on/off)/Start-Stop Switch faulty

Insufficient performance Several systems

may simultaneously

be affected

Engine idling poor Air filter contaminated, carburetor contaminated, muffler

clogged, exhaust duct in the cylinder clogged

Drain fuel

Humidity

1 ... 18 19 20

Comments to this Manuals

No comments

Makita EM2600U Instruction Manual Page 19

Comments to this Manuals

Related products and manuals for Grass trimmers Makita EM2600U