Makita JR3020 User Manual

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.Recipro SawMODEL JR3

10ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other acc

Memo11

Memo12

13FoldCutStampTimbreMakita Canada Inc.1950 Forbes Street,Whitby, OntarioL1N 7B7

14Your answers to the following questions are appreciated.Date Purchased Model No.Serial No.Initial Last NameStreet AddressCity ProvinceAGE:Male Femal

15Factory Service CentresFor the authorized service centre nearest you please refer to the local yellow pages directory under “tools” or con-tact our

Warranty PolicyEvery Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to be free of defects fromworkmanship

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

35.Avoid body contact with grounded sur-faces such as pipes, radiators, ranges andrefrigerators. There is an increased risk ofelectric shock if your b

4SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcould result in

59.Do not leave the tool running. Operate thetool only when hand-held.10.Always switch off and wait for the blade tocome to a complete stop before rem

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Adjusting

7Switch actionCAUTION:• Before plugging in the tool, always check to see that theswitch trigger actuates properly and returns to the “OFF”position whe

8Installing or removing saw bladeCAUTION:• Always clean out all chips or foreign matter adhering tothe blade, blade clamp and/or slider. Failure to do

9Press the shoe firmly against the workpiece. Do not allow thetool to bounce. Bring the blade into light contact with theworkpiece. First, make a pilo