Makita 433ODWA Instruction Manual download pdf (Page 11)

Bevel

cutting

CAUTION:

Always remove the battery from the tool before making any adjustments

With the base tilted, you can make bevel

cuts at any angle between

and

45"

(left

or right). Loosen the bolt on the bottom

the tool. Move the base

that the bolt

positioned in the center

the cross-shaped

slot in the base.

Tilt the base until the desired bevel angle

is obtained. The edge

the motor housing

indicates the bevel angle by graduations.

Then tighten the bolt to secure the base.

Flush cutting

Loosen the bolt

the bottom

the tool

and slide the base all the way back. Then

tighten the bolt to secure the base.

Cross-shaped

slot

Edge

motor housing

1 ... 10 11 12 ... 20

No comments

Makita 433ODWA Instruction Manual Page 11