Makita XPH06Z Use and Care Manual download pdf (Page 7)

Speed change

013964

CAUTION:

• Always set the speed change lever fully to the

correct position. If you operate the tool with the

speed change lever positioned halfway between

the "1" side and "2" side, the tool may be

damaged.

• Do not use the speed change lever while the tool

is running. The tool may be damaged.

• If the tool speed is coming down extremely during

the operation with "2", slide the lever to the "1" and

restart the operation.

Position of speed

adjusting lever

Speed Torque

Applicable operation

Low

High Low

High Heavy loading operation

Light loading operation

013983

To change the speed, switch off the tool first. Select the

"2" side for high speed or "1" for low speed but high

torque. Be sure that the speed change lever is set to the

correct position before operation.

Selecting the action mode

CAUTION:

• Always set the ring correctly to your desired mode

mark. If you operate the tool with the ring

positioned halfway between the mode marks, the

tool may be damaged.

013971

This tool has three action modes.

Drilling mode (rotation only)

Hammer drilling mode (rotation with hammering)

Screwdriving mode (rotation with clutch)

Select one mode suitable for your work. Turn the action

mode changing ring and align the mark that you

selected with the arrow on the tool body.

Adjusting the fastening torque

013971

The fastening torque can be adjusted in 16 steps by

turning the adjusting ring. Align the graduations with the

arrow on the tool body. You can get the minimum

fastening torque at 1 and maximum torque at 16.

Before actual operation, drive a trial screw into your

material or a piece of duplicate material to determine

which torque level is required for a particular application.

The following shows the rough guide of the relationship

between the screw size and graduation.

1. Action mode

changing ring

2. Adjusting ring

3. Graduation

4. Arrow

1. Action mode

changing ring

2. Adjusting ring

3. Graduation

4. Arrow

1. Speed change

lever

1 2 3 4 5 6 7 8 ... 32

Comments to this Manuals

No comments

Makita XPH06Z Use and Care Manual Page 7

Comments to this Manuals

Related products and manuals for Cordless combi drills Makita XPH06Z