Makita BTP140RFE Specifications download pdf (Page 14)

Raise the arm part of the spring and then place it in the recessed part of the

housing with a slotted bit screwdriver of slender shaft or the like.

Use pliers to remove the carbon brush cap of the carbon brushes. Take out the

worn carbon brushes, insert the new ones and replace the carbon brush cap

in reverse.

Make sure that the carbon brush cap have fit into the holes in brush holders

securely.

Reinstall the rear cover and tighten two screws securely.

After replacing brushes, insert the battery cartridge into the tool and break in

brushes by running tool with no load for about 1 minute. Then check the tool

while running and electric brake operation when releasing the switch trigger. If

electric brake is not working well, ask your local Makita service center for

repair.

To maintain product SAFETY and RELIABILITY, repairs, any other mainte-

nance or adjustment should be performed by Makita Authorized Service Cent-

ers, always using Makita replacement parts.

ACCESSORIES

CAUTION:

• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The

use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or

attachment for its stated purpose.

If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.

1. Spring

2. Arm

3. Recessed part

006260

1. Carbon brush cap

006261

1. Hole

2. Carbon brush cap

006304

• Screw bits

• Hook

• Plastic carrying case

• Various type of Makita genuine batteries and

chargers

• Stopper (for impact driving)

• Bit piece

• Hybrid drill chuck

1 ... 13 14 15 16

No comments

Makita BTP140RFE Specifications Page 14