Makita BTP140RFE Specifications Page 1

Browse online or download Specifications for Cordless combi drills Makita BTP140RFE. Makita BTP140RFE cordless combi drill User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
INSTRUCTION MANUAL
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH
Cordless 4 Mode
Impact Driver
MODEL BTP130
MODEL BTP140
007155
Page view 0
1 2 ... 16

Summary of Contents

Page 1 - Impact Driver

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.ENGLISHCordless 4 Mo

Page 2 - SPECIFICATIONS

10OPERATIONCAUTION:• Always insert the battery cartridge all the way until it locks in place. If youcan see the red part on the upper side of the butt

Page 3 - SAVE THESE INSTRUCTIONS

11Tightening boltsThe proper fastening torque may differ depending upon the kind or size of thescrew/bolt, the material of the workpiece to be fastene

Page 4 - SPECIFIC SAFETY RULES

12CAUTION:• If the tool is operated continuously until the battery cartridge hasdischarged, allow the tool to rest for 15 minutes before proceeding wi

Page 5 - FOR BATTERY CARTRIDGE

13Drilling in metalTo prevent the bit from slipping when starting a hole, make an indentation witha center-punch and hammer at the point to be drilled

Page 6 - DESCRIPTION

14Raise the arm part of the spring and then place it in the recessed part of thehousing with a slotted bit screwdriver of slender shaft or the like.Us

Page 8 - ASSEMBLY

Makita Corporation Anjo, Aichi, Japan884655-223

Page 9 - Hook (Accessory)

2SPECIFICATIONS• Due to our continuing programme of research and development, the specifications herein are subject to changewithout notice. • Note: S

Page 10 - OPERATION

3EC-DECLARATION OF CONFORMITYWe declare under our sole responsibility that this productis in compliance with the following standards of stan-dardized

Page 11 - Hammer drilling operation

412. Remove any adjusting key or wrench beforeturning the power tool on. A wrench or a key leftattached to a rotating part of the power tool mayresult

Page 12 - Drilling operation

58. Wear ear protectors with impact drills. Exposureto noise can cause hearing loss.SAVE THESE INSTRUCTIONS.MISUSE or failure to follow the safetyrule

Page 13 - MAINTENANCE

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off and the battery cartridge isremoved before adjusting or checking functio

Page 14 - ACCESSORIES

7CAUTION:• Always check the direction of rotation before operation.• Use the reversing switch only after the tool comes to a complete stop.Changing th

Page 15

8Sliding to the mark is high rotation and the mark is low rotation.Before operation, always make sure that the lever is correctly set to yourdesir

Page 16 - 884655-223

9For other countries1. To install the bit, pull the sleeve in the direction of the arrow and insertthe bit into the sleeve as far as it will go. Then

Comments to this Manuals

No comments