Makita LH1040F User Manual download pdf (Page 2)

P 2 / 20

Repair

1) Apply 12g of Makita grease N No.1 to the gear portion.

2) Apply an appropriate amount of Makita grease N No.1 to each of the listed below.

Although these slide surfaces are factory-greased with Makita grease N No.1, you apply other type of grease such as

Makita grease N No.2 or the like.

[2] LUBRICATION

1R235/ Round Bar for Arbor 6-100* (2 pcs) Disassembling Blade case

1R269/ Bearing Extractor Removing Ball bearings

1R208/ 90 Degrees Set Square Squaring Saw blade with Base

1R229/ 1/4" Hex shank bit for M5 Removal/Installation of screws that fasten Bearing box

1R306/ Ring Spring Removing Jig** Disassembling Blade case

1R340/ Wrench for Bearing Retainer

*Note: Disassembling can be done also using two Phillips screwdrivers of 6.5X100mm or larger size instead.

**Note: Disassembling can be done also using 1R201/ Jig for Retaining Ring.

Removal/Installation of Bearing retainer

1R291/ Retaining Ring S and R Pliers Removal/Installation of the Retaining ring

1R045/ Gear Extractor (large) Disassembling Gear housing cover and Bearing box

1R035/ Bearing Setting Plate 15.2 Press-fitting Ball bearings

Tool No./ Description Use for

[1] NECESSARY REPAIRING TOOLS

CAUTION: For your safety, before maintenance or repair, be sure to;

1. Disconnect the machine from the power source.

2. Remove the saw blade from the machine.

Pipe 9-126

Lever 54

Switch box

Compression

spring 27

Safety cover

Torsion

spring 36

Blade case

Position

No. Parts item Portion to be lubricated

Center cover24

Gear portion

Accepting hole for compression spring 27

The pivotal portion where arm contacts

The portion where torsion spring 36 contacts

Table support99

101

The elliptic punched hole where lever 54 contacts, when table support

is slidden up and down.

The elliptic punched hole where pipe 9-126 contacts, when support plates

are slidden up and down.

The side where (1) Blade Case contacts, when table support

is slidden up and down.

Support plate

Fig.1-1

The appropriate amount is 12g.

1 2 3 4 5 6 7 ... 19 20

Comments to this Manuals

No comments

Makita LH1040F User Manual Page 2

Comments to this Manuals

Related products and manuals for Circular saws Makita LH1040F