Makita 51778 Instruction Manual

7-iw Hypoid Saw Blade diameter 185 mm (7-1/4”) MODEL 51778 MODEL 52778 No load speed Overall Net Max. cutting capacities I 50’ 450 (RPM) length we

Adjusting depth of cut I Loosen the lever on the depth guide and move the base up or down. At the desired depth of cut, secure the base by tighten

Switch action To start the tool, simply pull the trigger. Release the trigger to stop. CAUTION : Before plugging in the tool, always check to see th

MAINTENANCE CAUTION : Always be sure that the tool is switched off and unplugged before attempting to perform Use a screwdriver to remove the bru

ACC E SO R I ES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of a

Sep-07- 95 US 185 mm (744”) HYPOID SAW Model 51 77B/5277B Note: The switch and other part configurations may differ from country to country. 14

MODEL 51778152778 'EM DESCRlPTlON 10 11 Sep.-07-'95 US ';"OM ,& DESCRIPTION 11 21 31 41 51 61 71 81 91 3 1 MACHINE 48 49 50 51

MAKITA LIMED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thorou ly ins ected and tested before leaving the factory. It is warranted to be

GENERAL SAFETY RULES (For All Tools) WARNING! Read and understand all instructions. Failure to follow all instructions listed below, may result in ele

11. Avoid accidental starting. Be sure switch is off before plugging in. Carrying tools with your finger on the switch or plugging in tools that have

Specific Safety Rules 1. DANGER! Keep hands away from cutting area and blade. Keep your second hand on auxiliary handle, or motor housing. If both ha

11. Causes and Operator Prevention of Kickback: Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an uncontrolled saw

Do not use dull or damaged blade. Unsharpened or improperly set blades produce narrow kerf causing excessive friction, blade binding and KICKBACK. Bla

15. Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the c

Described below are symbols commonly listed on tools. v ... volts A ... amperes Hz ...

OPE R AT I 0 N Removing or installing saw blade CAUTION: Always be sure that the tool is switched off and unplugged before removing or installing the