Makita HR2641X1 Use and Care Manual download pdf (Page 8)

Press the lock button on the grip base in the direction of arrow

shown in the figure and with the lock button being pressed

insert the depth gauge into the hex. hole in the grip base

015348

At this time, the depth gauge needs to be inserted so that

its toothed side is directed to the toothed side of hex hole

marking on the grip base as shown in the figure.

015349

Adjust the depth gauge to the desired depth by moving it

back and forth while pressing the lock button. After the

adjustment, release the lock button to lock the depth gauge.

015350

NOTE:

• Inserting the depth gauge with its toothed side not

directed to the toothed side of hex hole marking on

the grip base as shown in the figure does not allow

the depth gauge to be locked.

Dust cup (optional accessory)

010731

Use the dust cup to prevent dust from falling over the

tool and on yourself when performing overhead drilling

operations. Attach the dust cup to the bit as shown in

the figure. The size of bits which the dust cup can be

attached to is as follows.

Bit diameter

Dust cup 5 6 mm - 14.5 mm

Dust cup 9

12 mm - 16 mm

006406

There is another type of dust cup (optional accessory)

which helps you prevent dust from falling over the tool

and on yourself when performing overhead drilling

operations.

Installing or removing the dust cup

(optional accessory)

015351

Before installing the dust cup, remove the bit from the

tool if installed on the tool. Install the dust cup (optional

accessory) on the tool so that the

symbol on the

dust cup is aligned with the grooves in the tool.

015352

To remove the dust cup, pull the chuck cover in the

direction as shown in the figure and with the chuck

cover pulled take the bit out of the tool.

015353

And then grab the attachment at the foot of dust cup

and take it out.

1. Attachment at

the foot of dust

cup

1. Bit

2. Chuck cover

symbol

2. Grooves

3. Dust cup

1. Dust cup

1. Toothed side of

hex hole

marking on the

grip base

Toothed side of

the depth gauge

1. Lock button

1. Toothed side of

hex hole

marking on the

grip base

Toothed side of

the depth gauge

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comments to this Manuals

No comments

Makita HR2641X1 Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Makita HR2641X1