Makita HR2641X1 Use and Care Manual download pdf (Page 10)

After drilling the hole, use the blow-out bulb to clean the

dust out of the hole.

Chipping/Scaling/Demolition

015356

Set the action mode changing knob to the symbol.

Hold the tool firmly with both hands. Turn the tool on

and apply slight pressure on the tool so that the tool will

not bounce around, uncontrolled. Pressing very hard on

the tool will not increase the efficiency.

Drilling in wood or metal

CAUTION:

• Never use "rotation with hammering" when the

quick change drill chuck is installed on the tool.

The quick change drill chuck may be damaged.

Also, the drill chuck will come off when reversing

the tool.

• Pressing excessively on the tool will not speed up

the drilling. In fact, this excessive pressure will

only serve to damage the tip of your bit, decrease

the tool performance and shorten the service life

of the tool.

• There is a tremendous twisting force exerted on

the tool/bit at the time of hole breakthrough. Hold

the tool firmly and exert care when the bit begins

to break through the workpiece.

• A stuck bit can be removed simply by setting the

reversing switch to reverse rotation in order to

back out. However, the tool may back out abruptly

if you do not hold it firmly.

• Always secure small workpieces in a vise or

similar hold-down device.

Set the action mode changing knob to the

symbol.

You can drill up to 13 mm diameter in metal and up to

32 mm diameter in wood.

For Model HR2631F, HR2641, HR2630

015357

Use the drill chuck assembly (optional accessory).

When installing it, refer to "Installing or removing the bit"

described on the previous page.

015358

To install the bit, place it in the chuck as far as it will go.

Tighten the chuck by hand. Place the chuck key in each

of the three holes and tighten clockwise. Be sure to

tighten all three chuck holes evenly.

To remove the bit, turn the chuck key counterclockwise

in just one hole, then loosen the chuck by hand.

For Model HR2631FT, HR2320T, HR2630T

015339

015340

Use the quick change drill chuck as standard equipment.

When installing it, refer to "changing the quick change

chuck for SDS-plus " described on the previous page.

1. Spindle

2. Quick change

drill chuck

3. Change cover

line

4. Change cover

1. Quick change

chuck for SDS-

plus

2. Change cover

line

3. Change cover

1. Chuck key

1. Drill chuck

assembly

(optional

accessory)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 47 48

Comments to this Manuals

No comments

Makita HR2641X1 Use and Care Manual Page 10

Comments to this Manuals

Related products and manuals for Power tools Makita HR2641X1