Makita HM1307CB User Manual download pdf (Page 6)

Facing taper formed side

to Tool retainer hole,

insert Tool retainer shaft.

Facing this depressed portion

to the round side of Tool holder,

insert Tool retainer shaft into the

holes of Tool retainer.

P 6/ 19

Repair

[3] DISASSEMBLY/ASSEMBLY

[3]-2A. Tool holder section (HM1307CB, HM1317CB) (cont.)

ASSEMBLING

Fig. 8

Fig. 9

(1) Assemble Tool retainer pole, Compression spring 17, Retainer ring and Pin 4 using 1R347, 1R045 and 1R346. (Fig. 7A)

(2) While paying attention to directions of the parts shown in Fig. 8, assemble Tool retainer and Tool retainer shaft. (Fig. 9)

Tool holder

Facing the Arch formed

portion to the round side

of Tool holder, set Tool

retainer in place.

round side of

Tool holder

Tool retainer

Note in Assembly of Tool retainer and Tool retainer shaft

round side of

Tool holder

Tool retainer

pole

Tool holder

Tool retainer

shaft

Tool retainer shaft

Tool retainer pole

Retainer ring

Tool retainer

After inserting Tool retainer

shaft, pass thin bar through

the holes of Tool retainer and

Tool retainer shaft in order to

set the Passing holes for Spring

pin 8-40 to the in-line position.

Compression spring 17 pulls Tool retainer pole toward Retainer ring side. Consequently, holes for

passing Tool retainer shaft are not in line.

Pass Tool retainer shaft through the holes of Tool retainer, Tool retainer pole and Tool holder while

lifting up Tool retainer pole to set in-line with a slotted head screwdriver.

Spring

pin 8-40

Mount Spring

pin 8-40.

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Comments to this Manuals

No comments

Makita HM1307CB User Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Makita HM1307CB