Makita HM1307CB User Manual download pdf (Page 2)

P 2/ 19

Repair

CAUTION: Repair the machine in accordance with “Instruction manual” or “Safety instructions”.

[1] NECESSARY REPAIRING TOOLS

[2] LUBRICATIONS

Fig. 1

HM1307CB. HM1317CB

Code No. Description Use for

1R003 Retaining ring S pliers ST-2N Removing Ring spring 55 from Cylinder

1R023 Pipe ring (for Arbor press) Supporter when removing Cylinder section with 1R263

1R022/ 356 Bearing plate (for Arbor press) Pressing down Sleeve when removing Ring spring 55 from Cylinder

1R031 Bearing setting pipe 28-20.2 Assembling Helical gear 47 to Crank shaft

1R045 Gear extractor (large) Removing Counter shaft

1R258 V block Assembling Helical gear 47 to Crank shaft

1R212 Tip for Retaining ring pliers Attachment for 1R003

1R217 Ring 22 Supporting Crank housing

1R228 1/4” Hex shank bit for M4 Unscrewing / Screwing M4 Hex socket head bolts

1R230 1/4” Hex shank bit for M6 Unscrewing / Screwing M6 Hex socket head bolts

1R231 1/4” Hex shank bit for M8 Unscrewing / Screwing M8 Hex socket head bolts

1R246 Round bar for arbor 18-100 Removing Crank shaft from Helical gear 47

1R252 Round Bar for arbor 30-100 Supporting Crank shaft when assembling Helical gear 47

1R263 Bearing extractor Removing Cylinder section

1R269 Bearing extractor Removing Ball bearing of Commutator side

1R348 Spring pin 8 remover Removing Spring pin 8-40 from Tool retainer for HM1307CB, HM1317CB

1R239/ 284 Round bar for arbor 10-100 / 50 Removing Tool retainer from Tool holder for HM1307C, HM1317C

1R291 Retaining ring S and R pliers Removing / Mounting Retaining ring S-8 from / to Counter shaft

1R306 Ring spring removing jig Disassembling AVT mechanism

1R346 Center attachment for 1R045 Using with 1R045 to remove Counter shaft

1R347 Tool retainer pole removing tool Removing Tool retainer pole from Tool retainer

Item No.

Apply lubricants to the portions designated with triangles to protect parts and product from unusual abrasion.

(Figs. 1 and 2.)

Description

Sleeve 43

Tool retainer for

HM1307C and HM1317C

X ring 36

O ring 36

Inner wall for smooth action of Impact bolt

Drum portion for smooth turning in Bit change

Whole portion for smooth action of Impact bolt

Whole portion for smooth action of Sleeve

Portion to lubricate Lubricant Amount

a little

Tool holder

O ring 45

Whole portion for smooth action of Impact bolt

Tool holder

Impact bolt

Tool retainer

Retainer sleeve

Compression spring 17

Shank type: 28.6mm Hex

HM1307C. HM1317C

Shank type: 30mm Hex

Impact bolt

Tool holder section

Makita grease R

No.00

1 2 3 4 5 6 7 ... 18 19

Comments to this Manuals

No comments

Makita HM1307CB User Manual Page 2

Comments to this Manuals

Related products and manuals for Power tools Makita HM1307CB