Makita BJR182 User Manual download pdf (Page 5)

• Always switch off the tool before insertion or

removal of the battery cartridge.

• To remove the battery cartridge, withdraw it from

the tool while sliding the button on the front of the

cartridge.

• To insert the battery cartridge, align the tongue on

the battery cartridge with the groove in the housing

and slip it into place. Always insert it all the way

until it locks in place with a little click. If you can see

the red part on the upper side of the button, it is not

locked completely. Insert it fully until the red part

cannot be seen. If not, it may accidentally fall out of

the tool, causing injury to you or someone around

you.

• Do not use force when inserting the battery car-

tridge. If the cartridge does not slide in easily, it is

not being inserted correctly.

Adjusting the shoe

When the blade loses its cutting efficiency in one place

along its cutting edge, reposition the shoe to utilize a

sharp, unused portion of its cutting edge. This will help to

lengthen the life of the blade. To reposition the shoe,

push the shoe button in the “A” direction with a click and

reposition as shown in the figure which allows you to

make five-way adjustment. To secure the shoe, push the

shoe button in the “B” direction with a click.

Switch action

CAUTION:

• Before inserting the battery cartridge into the tool,

always check to see that the switch trigger actuates

properly and returns to the “OFF” position when

released.

• When not operating the tool, depress the lock-off

button from A side to lock the switch trigger in the

OFF position.

To prevent the switch trigger from accidentally pulled, the

lock-off button is provided.

To start the tool, depress the lock-off button from B side

and pull the switch trigger.

Tool speed is increased by increasing pressure on the

switch trigger. Release the switch trigger to stop. After

use, always press in the lock-off button from A side.

Electric brake

This tool is equipped with an electric brake. If the tool

consistently fails to quickly stop after switch trigger

release, have tool serviced at a Makita service center.

Lighting up the front lamp (For BJR181)

CAUTION:

• Do not look in the light or see the source of light

directly.

Pull the switch trigger to light up the lamp. The lamp

keeps on lighting while the switch trigger is being pulled.

The light automatically goes out 10 - 15 seconds after the

switch trigger is released.

NOTE:

• Use a dry cloth to wipe the dirt off the lens of lamp.

Be careful not to scratch the lens of lamp, or it may

lower the illumination.

Hook (For BJR181)

1. Shoe

2. Shoe button

1. Shoe button

2. Shoe

1. Lock-off button

2. Switch trigger

006898

006899

006900

1. Lamp

1. Hook

006901

006902

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

Makita BJR182 User Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Makita BJR182