Pneumatic Finish Nailer Min. hose diameter Dimensions (L x H x WJ 308 mm x 363 mm x 87 mm Air pressure Nail length hail capacity 6.0 mm I1 4”) 112-
TOOL INSTALLATION INSTRUCTIONS AND USE Lubrication To insure maximum performance, install an air set (oiler, regulator, air filter) as close as pos
Unloading nailer CAUTION: Always disconnect the air hose before unloading the nailer. Pull the pusher fully to the rear and depress the lock button. W
Selecting compressor The air compressor must comply with the requirements of Select a compressor that has ample pressure and air output to assure cost
Operation 1) To drive a nail, you may place the contact element 2) Pull the trigger first and then place the contact element No. 1 method is f
Jammed nailer CAUTIO N : Always disconnect the air hose before clearing a jam. The door of this tool is designed to open automatically when a jam oc
Nails Handle nail strips and their box carefully. If the nail strips have been handled roughly, they may be out of shape or their connector breaks,
MAINTENANCE CAUTION: Always be sure that the air hose is disconnected from the tool before attempting to perform inspection or maintenance. Maintenan
Maintenance of compressor, air set and air hose After operation, always drain the compressor tank and the air filter. If moisture is allowed to ente
MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to
IMPORTANT SAFETY INSTRUCTIONS WARNING: WHEN USING THIS TOOL, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF PERSO
General Tool Handling Guidelines: 1. Always assume that the tool contains fasteners. 2. Do not point the tool toward yourself or anyone whether it con
There may be local regulations concerning noise which must be complied with by keeping noise levels within prescribed limits. In certain cases, sh
*Always check the tool for its overall condition and loose screws before operation. Tighten as required. Make sure all safety systems are in working o
Use only nails specified in this manual. The use of any other nails may cause malfunction of the tool. I Do not permit those uninstructed to use the t
On rooftops and other high locations, nail as you move forward. It is easy to lose your footing if you nail while inching backward. When nailing agai
When the air hose is connected, do not carry the tool with your finger on the trigger or hand it to someone in this condition. Accidental firing
Perform cleaning and maintenance right after finish- ing the job. Keep the tool in tip-top condition. Lubricate moving parts to prevent r
Comments to this Manuals