Makita 3707F Specifications download pdf (Page 7)

Installing or removing trimmer bit

CAUTION:

• Do not tighten the collet nut without inserting a bit, or the

collet cone will break.

• Useonlythewrenchesprovidedwiththetool.

Insert the bit all the way into the collet cone and tighten the

collet nut securely with the two wrenches. To remove the bit,

follow the installation procedure in reverse.

OPERATION

Set the tool base on the workpiece to be cut without the bit

making any contact. Then turn the tool on and wait until the

bit attains full speed. Move the tool forward over the work-

piece surface, keeping the tool base flush and advancing

smoothly until the cutting is complete.

When doing edge cutting, the workpiece surface should be

on the left side of the bit in the feed direction.

NOTE:

• Moving the tool forward too fast may cause a poor

quality of cut, or damage to the bit or motor. Moving the

tool forward too slowly may burn and mar the cut. The

proper feed rate will depend on the bit size, the kind of

workpiece and depth of cut. Before beginning the cut on

the actual workpiece, it is advisable to make a sample

cut on a piece of scrap lumber. This will show exactly

how the cut will look as well as enable you to check

dimensions.

1. Loosen

2. Tighten

3. Hold

001983

1. Workpiece 2. Bit revolving direction

3.Viewfromthetopofthetool 4.Feeddirection

001984

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Makita 3707F Specifications Page 7