OutputStandard equipmentNote: The standard equipment for the tool shown above may vary by country.Chuck key S-13 ... 1 (for DS4010, DS4011)Ch
P 2/ 8RepairCAUTION: Repair the machine in accordance with “Instruction manual” or “Safety instructions”.[1] NECESSARY REPAIRING TOOLS[2] LUBRICATION
P 3/ 8Repair[3]-2. Drill chuck, Gear, SpindleFig. 4Fig. 61R1392. Fit the flats of Spindle to the notch of 1R139 and then hold 1R139 in vise.3. Att
P 4/ 8Repair(2) Gears can be removed as illustrated in Figs. 7 and 8.(3) Remove Ball bearings on Spindle and Gear complete 7-41 with 1R269 as illustra
P 5/ 8Repair(1) Assemble Gear section as illustrated in Figs. 10 and 11.[3] DISASSEMBLY/ASSEMBLY[3]-2. Gear, SpindleFig. 10Fig. 94. Set Pin 3 in place
Circuit diagramBlueBrownColor index of lead wires' sheathBlackSwitch(Noise suppressoris built in.) Line filterFig.D-1Field viewed fromArmature fa
Fig.D-2Ato Switch Motor Housing viewed from Armature fan sidePass Field lead wires (black, purple, white)through this hole.Pass Field lead wires (blue
Wiring diagram (cont.)Fig.D-3A2. Inflect their Insulated connectors of the Field lead wires until they touch Screw heads.3. Insulated connecto
Comments to this Manuals