Makita BMR100 Instruction Manual download pdf (Page 5)

1. Soft bended rod

antenna

Install the Soft

bended rod antenna as show in the figure.

Using Supplied AC power adaptor

1. DC IN socket

2. Input terminal

(AUX IN1)

Remove the rubber protector and insert the adaptor plug

into the DC socket on the front side of the radio. Plug the

adaptor into a standard mains socket outlet. Whenever

the adaptor is used, the battery pack are automatically

disconnected. The AC adaptor should be disconnected

from the main supply when not in use.

Setting the clock

1. Clock can be set either when the radio is power on or

off.

2. Display will show “-: - -” when the back up batteries

are installed.

3. Long press the time set button for more than

2 seconds, display will flash time set symbol and

also the hour digit, followed by a beep.

4. Rotate Tuning control to set the required hour.

5. Press button to confirm hour setting, the minute

digit will flash.

6. Rotate Tuning control to set the required minute.

7. Press the button again to complete clock setting.

Operating the radio

This radio equips with three tuning methods – Scan

tuning, Manual tuning and Memory presets recall.

Scan Tuning

1. Press the Power button to turn on the radio.

2. Select the required waveband by pressing the Band

button. Make sure the rubber bended rod antenna has

been well placed for best FM reception. For AM (MW)

band, rotate the radio to get best signal. Try to avoid to

operate the radio next to computer screen and other

equipment which will cause interference to the radio.

3. Press and release Scan button (long press Scan

button more than 2 seconds will activate time setting),

LCD display will flash Scan symbol and the radio will

up search and stop automatically when it finds a radio

station,. Press the Scan button again to pick up the

found station.

Note:

A stereo symbol will appear on the display, if the

station found is a stereo station.

Note:

The radio will continue to search next available

stations if you do not press Scan button again when it

finds a radio station.

4. Rotate the Volume control to get required sound level.

LCD display will show sound level changes.

Note:

During operating volume control, you can press in

Tuning/Volume control knob to change volume control

to tuning control status.

5. To turn off the radio, press the Power button. Display

will show OFF.

Manual Tuning

1. Press the Power button to turn on the radio.

2. Select the required waveband by pressing the Band

button. Adjust the antenna as described above.

3. A single rotary to the Tuning control will change the

frequency in the following increment:

FM: 50 or 100 kHz

AM (MW): 9 or 10 kHz

Note:

If the radio is in volume control status, press in the

tuning/volume control to become Tuning status.

4. Keep on rotating the Tuning control until the required

frequency shown on the display.

5. Rotate the volume control to get required sound level.

6. To turn off the radio, press the Power button. Display

will show OFF.

Storing stations in preset memories

There are 5 memory presets for each waveband.

1. Press the Power button to turn on the radio.

2. Tune to required station using one of the methods

previously described.

3. Press and hold down the required preset until radio

beeps. The preset number will appear in the display

and the station will be stored under chosen preset

button.

4. Repeat this procedure for the remaining presets.

5. Stations stored in preset memories can be overwritten

by following above procedures.

Recall stations from preset memories

1. Press the power button to turn on the radio.

2. Select the required waveband.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Makita BMR100 Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Alarm clocks Makita BMR100