Makita VC4710 Use and Care Manual download pdf (Page 7)

Makita VC4710

Original Instruction

Electrical connection

It is recommended that the vacuum should be connected via a GFCI.

Extension cord

1. As an extension cord, only use the version specified by the man-

ufacturer or one of a higher quality. See operating instructions.

2. When using an extension cord, check the minimum cross-sec-

tions of the cable:

WARNING

This appliance is for use on a nominal 120-V circuit and

has a grounding attachment

plug that looks like the plug illustrated.

Make sure that the appliance is connected to an outlet

having the same configuration as the plug. No adaptor

should be used with this appliance.

Cable length Cross section

< 15 A

0 - 25 feet

14 AWG

25 - 50 feet 12 AWG

> 50 feet Not recommended

Only carry out maintenance work described in the operating instruc-

tions. Be sure that the vacuum is switched off and unplugged.

Before using the vacuum make sure that the voltage shown on the

rating plate on the vacuum corresponds with the main voltage. This

vacuum is equipped with a thermal cut-out to protect the motor and

other vital vacuum parts from overheating. Should the vacuum cut

out, check that nothing blocks the motor cooling inlet on the backside

of the vacuum, wait for the vacuum to cool down and start again. If

the issue persists, contact Makita factory service center.

Maintenance, cleaning and

repair

1 2 3 4 5 6 7 8 ... 72

No comments

Makita VC4710 Use and Care Manual Page 7