Makita RF1100 User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
OPERATION (Fig. 8)
Set the tool base on the workpiece to be cut without
the bit making any contact. Then turn the tool on and
wait until the bit attains full speed. Lower the tool
body with pressing the lock lever down. Release the
lock lever at the lowest position and push it further to
lock the tool body securely. Move the tool forward
over the workpiece surface, keeping the tool base
flush and advancing smoothly until the cutting is com-
plete.
When doing edge cutting, the workpiece surface
should be on the left side of the bit in the feed direc-
tion.
NOTE:
• Make sure that the tool raises automatically when
the lock lever is loosened. The position of the bit
must be higher than the tool base when not operat-
ing.
Moving the tool forward too fast may cause a poor
quality of cut, or damage to the bit or motor. Moving
the tool forward too slowly may burn and mar the
cut. The proper feed rate will depend on the bit size,
the kind of workpiece and depth of cut. Before
beginning the cut on the actual workpiece, it is
advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look
as well as enable you to check dimensions.
• When using the straight guide, be sure to install it
on the right side in the feed direction. This will help
to keep it flush with the side of the workpiece.
Page view 3
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments