Makita HR2010 User Manual

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comR

10Use a screwdriver to remove the brush holder caps. Take outthe worn carbon brushes, insert the new ones and securethe brush holder caps.LubricationT

11ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other acc

Memo12

13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

3trician to install a polarized outlet. Do notchange the plug in any way. Double insula-tion eliminates the need for the three wiregrounded power co

4one tool, may become hazardous when usedon another tool.SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-t

5breakdown or accident. Check tightnessof screws carefully before operation.6.In cold weather or when the tool has notbeen used for a long time, let t

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7Bit grease (optional accessory)Coat the bit shank head beforehand with a small amount ofbit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck lubr

8Depth gaugeThe depth gauge is convenient for drilling holes of uniformdepth. Insert the depth gauge into the hole in the grip base.Adjust the depth g

9Blow-out bulb (optional accessory)After drilling the hole, use the blow-out bulb to clean the dustout of the hole.Drilling in wood or metalUse the op