Makita 5007NF Instruction Manual download pdf (Page 7)

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and

unplugged before adjusting or checking function on

the tool.

Adjusting depth of cut

008672

CAUTION:

• After adjusting the depth of cut, always tighten the

lever securely.

Loosen the lever on the depth guide and move the base

up or down. At the desired depth of cut, secure the base

by tightening the lever.

For cleaner, safer cuts, set cut depth so that no more

than one blade tooth projects below workpiece. Using

proper cut depth helps to reduce potential for dangerous

KICKBACKS which can cause personal injury.

Bevel cutting

008673

Positive stopper

Turn the positive stopper so that the arrow on it points

one of three positions (22.5°,45°,56°). Then, tilt the tool

base until it stops and secure the base with the lever. At

this time, the same angle as the one that the arrow points

is obtained.

Setting bevel angle

Loosen the lever and tentatively set the tool base at the

0°bevel angle, then tighten the lever securely.

Turn the positive stopper so that the arrow on it points

one of three positions (22.5°,45°,56°) that is equal to or

greater than the desired bevel angle.

Loosen the lever again and then tilt and secure the tool

base at the desired angle securely.

NOTE:

• When changing the positive stopper's position,

loosening the lever and tilting the bevel angle to

less than the desired stopper position number

allows to change it.

• When the arrow on the positive stopper points 22.5,

the bevel angle can be adjusted 0 - 22.5°;when the

arrow points 45, it can be adjusted 0 - 45°; when the

arrow points 56, it can be adjusted 0 - 56°.

Sighting

008674

For straight cuts, align the A position on the front of the

base with your cutting line. For 45° bevel cuts, align the B

position with it.

Switch action

008675

CAUTION:

• Before plugging in the tool, always check to see

that the switch trigger actuates properly and returns

to the "OFF" position when released.

To s tar t t he t oo l, s im pl y p ul l t he s wi tc h t ri gg er. R el ea se

the switch trigger to stop.

Lighting the lamp (For model 5007NF only)

008676

1. Lamp

1. Switch trigger

1. Base

1. Lever

2. Positive stopper

3. Arrow on

positive stopper

1. Lever

2. Depth guide

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita 5007NF Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Power universal cutters Makita 5007NF