Makita T221D Instruction Manual

Cordless Applicable staples Stanler Staple capacity Dimensions (L x W x H) Net weight I MODEL T221D MODEL T22lDW With Fast Charger Battery Cartridg

Driving staples Place the tool on the material to be fastened so that the front and the rear of the tool contact the material flat. Do not tip

MAINTENANCE CAUTION : Always remove the battery cartridge before attempting to perform inspection or main- tenance. To maintain product SAFETY a

ACCESSORIES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any

Jan -21- 92 US CORDLESS STAPLER Model T221D Note: The switch and other part configurations may differ from country to country. 13

MODEL T221D Jan.-21--'92 US __ 26 1 27 1 28 1 29 1 30 1 31 1 32 1 33 1 34 1 35 1 36 1 37 1 38 1 39 1 40 1 41 1 42 1 43 1 44 1 45 1 46 6

MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Evcry Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted

IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RI

14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15.

I M PO RTANT Length of Cord (Feet) AWG Size of Cord SAFETY 25 50 100 150 18 18 18 16 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. SAVE THESE INSTRUCTI

ADDITIONAL SAFETY RULES FOR CHARGER & BATTERY CARTRIDGE 1. Do not charge Battery Cartridge when temperature is BELOW 10°C (5OOF) 2. Do not att

ADDITIONAL SAFETY RULES 1. Always wear safety goggles or safety glasses with side shield, and a full face shield when needed. 2. Do not point the ej

Installing or removing battery cartridge Always switch off the tool before insertion 0 To remove the battery cartridge, pull out the set plate on t

Safety system Make sure all safety systems are in working order before operation. The tool must not operate if only the trigger is pulled or i

To secure the sub-magazine in place, push the sub-magazine while pressing the plate spring on the rear of the sub-magazine. CAUTION : 0 Always s