Makita 6832 Instruction Manual

Auto Feed Screwdriver No load speed (RPM) 0 -- 2,800 Screw strip 4 mm x 25 mm - 57 mm (5132" x 1" ~ 2-114") MODEL 6832 Variable Speed

Driving operation (Fig. 14) Switch on the tool by pressing the trigger and at the same time pushing the lock button. Hold the tool squarely a

Extension handle (optional accessory) (Fig. 17) Use of extension handle allows you to drive screws into floors while standing. Fig. 1 11

MAINTENANCE CAUTION : Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Replacing c

ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any

Mar.-30-'95 US AUTO FEED SCREWDRIVER Model 6832 Note: The switch, noise suppressor and other part configurations may differ from country to c

Mar.-30-'95 US MODEL 6832 ITEM NO. NO. USED DESCRIPTION $tD DESCRIPTION MACHINE ~ 1 2 3 4 5 6 7 8 9 10 I1 12 13 14 15 16 17 18 19 20 21 22 23 24

P MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted

IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE R

Ampere Rating More Not More Than Than 0- 6 6 - 10 10 - 12 12 - 16 3 Total Length of Cord in Feet 0 - 25 26 - 50 51 - 100 101 - 150 AWG 18 16 16

VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified o

Adjusting the stopper plate (Fig. 1, 2, 3 & 4) There are two kinds of stopper plates; one is for screws 25 mm (1") - 41 mm (1-5/8") lo

Adjust the stopper plate in accordance with the screw length as shown in Fig, 3 81 4. If necessary, loosen the bolts which secure the stopper plate

Setting the slide plate (Fig. 5 & 6) When driving screws 25 mm (I") - 41 mm (1-5/8") long, set the slide plate to the posi- tion shown

Installing the screw strip (Fig. 8 81 9) Insert the screw strip through the screw guide. Then insert it through the feeder box until the first screw

Switch action (Fig. 12) CAUTION : Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "