Makita 60921 Instruction Manual download pdf (Page 6)

Installing

removing battery cartridge

Always switch off the

tool

before insertion or removal of the battery cartridge.

*To

remove the battery cartridge, pull

out

the

set

plate on the

tool

and grasp both

sides of the cartridge while withdrawing

from the barrel.

insert the battery cartridge, align the

tongue on the battery cartridge with the

groove in the housing and slip

into

place. Snap the

set

plate back into place.

Be sure

close the set plate fully before

using the

tool.

not use force when inserting the battery cartridge.

If the cartridge does not slide in easily,

is not being inserted correctly.

Charging

Plug the fast charger into your power

source. Insert the battery cartridge

that

the plus and minus terminals on the bat-

tery cartridge are on the same sides as their

respective markings on the fast charger.

Insert the cartridge fully into the port

that

rests on the charger port floor.

Press the start button (red). The charging

light will come on and charging will begin.

the charging light does not come on,

press the reset button (yellow) first, then

the start button (red).

the charging light

goes out within

seconds even after pressing the reset button and start button a couple

of times, the battery cartridge

dead. (CAUTION: Wait for more than

seconds after

the charging light goes out

press the reset button again.) Replace

with a new one.

When the charging light goes out after about one hour, you may remove the fully charged

battery cartridge.

After charging, unplug the charger from the power source.

CAUTION

Your new battery cartridge is not charged. You will need

charge

before use.

.Do

not keep the button pressed in with tape,

etc.

or the circuit will not function pro-

perly. Also, a malfunction of the charger may result possibly causing overheating,

etc.

If you try

charge a cartridge from a just-operated

tool,

sometimes the charging light

will not come on. If this occurs, let the cartridge

cool

off for a while. Then re-insert

and try

charge

once more.

1 2 3 4 5 6 7 ... 17

Comments to this Manuals

No comments

Makita 60921 Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Makita 60921