Makita SLIDE COMPOUND SAW LS0711Z User Manual download pdf (Page 27)

Make sure that the pointer on the arm point to 0° on

the bevel scale on the arm holder. If it does not point

to 0°, loosen the screw which secures the pointer

and adjust the pointer so that it will point to 0°.

(2) 45° bevel angle

Adjust the 45° bevel angle only after performing 0°

bevel angle adjustment. To adjust left 45° bevel

angle, loosen the lever and tilt the blade to the left

fully. Make sure that the pointer on the arm points to

45° on the bevel scale on the arm holder. If the

pointer does not point to 45°, turn the 45° bevel

angle adjusting bolt (upper bolt) on the right side of

the arm until the pointer points to 45°.

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace

when they wear down to the limit mark. Keep the carbon

brushes clean and free to slip in the holders. Both carbon

brushes should be replaced at the same time. Use only iden-

tical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out

the worn carbon brushes, insert the new ones and secure

the brush holder caps.

After replacing brushes, plug in the tool and break in brushes

by running tool with no load for about 10 minutes. Then

check the tool while running and electric brake operation

when releasing the switch trigger. If electric brake is not

working well, ask your local Makita service center for repair.

1. Screw

2. Pointer

3. Bevel scale

002211

1. Arm holder

2. Arm

3. 45° bevel angle adjusting bolt

002465

1. Limit mark

001145

1. Screwdriver

2. Brush holder cap

002213

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

No comments

Makita SLIDE COMPOUND SAW LS0711Z User Manual Page 27