Makita Pump EW400R Instruction Manual download pdf (Page 16)

fore you take the pump to your

Makita dealer.

you still have trouble after com-

pleting the checks, take the pump

your nearest Makita dealer.

Remove the plug and connect it

the plug cap.

Pull the starter handle while putting the plug

against the engine ground.

Try with a new plug if the spark is weak or no

spark flies.

The ignition system is faulty if there is no spark

with a new plug.

Take your pump to your nearest Robin dealer.

there a

across the

electrode?

Before testing, carefully wipe

off

spilled fuel.

Put

the

plug

far

away

from

the

spark plug hole

possible.

Ground the side of the electrode to

any engine ground.

Pull the starter handle slowly and check

resistance is felt.

Starting

”

there

If little force is required to pull the starter handle,

failure

check

the spark plug is tightened firmly.

enough com-

pression?

If the spark plug is loose, tighten it.

the spark

plug wet with-

fuel?

I-

compression is still low, consult your nearest

dealer.

Choke (close choke lever) and pull the starter

handle five or six times.

Remove the plug and check

its electrode is

wet. If the electrode is wet, fuel is well supplied

to your engine.

When the electrode is dry, check where the fuel

stops. (Check the fuel intake of the carburetor

and fuel strainer intake.)

In case the engine does not start with well

supplied fuel, try using different fuel.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Makita Pump EW400R Instruction Manual Page 16

Comments to this Manuals