Makita 5036D Specifications download pdf (Page 5)

15. Avoid Cutting Nails.

Inspect for and remove all nails from lumber

before cutting.

16. Operate with proper hand support and proper

workpiece support.

WARNING:

It is important to support the workpiece properly

and to hold the saw firmly to prevent loss of

control which could cause personal injury. Fig. 4

illustrates typical hand support of the saw.

17. Place the wider portion of the saw base on that

part of the workpiece which is solidly sup-

ported, not on the section that will fall off when

the cut is made.

As example, Fig. 5 illustrates the RIGHT way to

cut off the end of a board, and Fig. 6 the WRONG

way. If the workpiece is short or small, clamp it

down. DON’T TRY TO HOLD SHORT PIECES BY

HAND! (Fig. 6)

18. Never attempt to saw with the circular saw held

upside down in a vise. This is extremely danger-

ous and can lead to serious accidents. (Fig. 7)

19. Before setting the tool down after completing a

cut, be sure that the lower (telescoping) guard

has closed and the blade has come to a com-

plete stop.

20. Using manufacturer data

• Ensure that the diameter, thickness and

other characteristics of the saw blade are

suitable for the tool.

• Ensure that the saw blade is suitable for the

spindle speed of the tool.

21. Do not use any abrasive wheel.

SAVE THESE INSTRUCTION

Fig. 4

A typical illustration of proper hand support and work-

piece support.

Fig. 5

Fig. 6

Fig. 7

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Makita 5036D Specifications Page 5