Makita LXHU02 Instruction Manual download pdf (Page 6)

Lithium-ion batteries with a star marking are equipped

with a protection system. This system automatically cuts

off power to the tool to extend battery life.

The tool will automatically stop during operation if the

tool and/or battery are placed under one of the following

conditions:

• Overloaded:

The tool is operated in a manner that causes

it to draw an abnormally high current.

In this situation, release the trigger switch on

the tool and stop the application that caused

the tool to become overloaded. Then pull the

trigger switch again to restart.

If the tool does not start, the battery is

overheated. In this situation, let the battery

cool before pulling the trigger switch again.

• Low battery voltage:

The remaining battery capacity is too low and

the tool will not operate. In this situation,

remove and recharge the battery.

Switch action

CAUTION:

• Before inserting the battery cartridge into the tool,

always check to see that the switch trigger

actuates properly and returns to the "OFF" position

when released.

012491

For your safety, this tool is equipped with a dual

switching system. To turn on the tool, press the lock-off

button and triggers A and B. Release either one of the

two pressed triggers to turn off. The sequence of

switching is unimportant as the tool only starts when

both switches are activated.

Indication lamp

012480

Running the tool allows the indication lamp to show the

battery cartridge capacity status.

When the tool is also overloaded and has stopped

during operation, the lamp lights up in red.

Refer to the following table for the status and action to

be taken for the indication lamp.

Note 1:

The time at which the indication lamp lights up varies by the temperature

around the work area and the battery cartridge conditions.

Indication lamp

The lamp blinks in red.

The lamp lights up in red.

(Note 1)

The lamp lights up in red.

(Note 1)

Status

This indicates the appropriate

time to replace the battery

cartridge when the battery

power becomes low.

This function works when the

battery power is almost used

up. At this time, tool stops

immediately.

Autostop due to overload.

Action to be taken

Recharge the battery cartridge

as soon as possible.

Recharge the battery cartridge.

Turn off the tool.

010970

1. Indication lamp

1. Switch trigger A

2. Switch trigger B

3. Lock-off button

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Comments to this Manuals

No comments

Makita LXHU02 Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Cordless hedge trimmers Makita LXHU02