Makita Angle Grinder User Manual download pdf (Page 7)

Installing or removing wheel guard

CAUTION:

• When using a depressed center grinding wheel/Multi-

disc, flex wheel, wire wheel brush or cut-off wheel, the

wheel guard must be fitted on the tool so that the closed

side of the guard always points toward the operator.

Mount the wheel guard with the protrusion on the wheel

guard band aligned with the notch on the bearing box. Then

rotate the wheel guard around 180 degrees. Be sure to

tighten the screw securely.

To remove wheel guard, follow the installation procedure in

reverse.

Installing or removing depressed center grinding

wheel/Multi-disc

WARNING:

• Always use supplied guard when depressed center

grinding wheel/Multi-disc is on tool. Wheel can shatter

during use and guard helps to reduce chances of

personal injury.

Mount the inner flange onto the spindle. Fit the wheel/disc on

the inner flange and screw the lock nut onto the spindle.

To tighten the lock nut, press the shaft lock firmly so that the

spindle cannot revolve, then use the lock nut wrench and

securely tighten clockwise.

To remove the wheel, follow the installation procedure in

reverse.

1. Wheel guard

2. Bearing box

3. Screw

1. Wheel guard

2. Bearing box

3. Screw

001654

9526NBH

001655

9527NB, 9528NB

1. Lock nut

2. Depressed center grinding wheel/

Multi-disc

3. Inner flange

001070

1. Lock nut wrench

2. Shaft lock

001082

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Makita Angle Grinder User Manual Page 7

Comments to this Manuals

Related products and manuals for Tools Makita Angle Grinder