Makita HR5001C User Manual

Voltage(V)No load speedBlows per minuteBit typeMax.capacitiesNet weightCord length(Work : Concrete)Current(A) Cycle(Hz) Continuous Rating(W) Max.Outpu

a. Assemble the ball bearing 6201, Flat washer 12(Outer dia. 24 mm) and torque limiter complete into the spiral bevel gear 12. (See the figure

To prevent abrasion and overheating, please apply the MAKITA grease R No.00 at the positions shown below. a. O ring of striker b. Ins

(Page 14 of 14) Switch Power supply cordP1P2ControllerBlackBlackRedWhiteWhiteOrange Orange Brush holderConnector VioletFieldConnector Brush holderWiri

Push-to-strike system EfficiencyAll enclosure is made of resin.Large change leverFor pointing job, you can usethis toolholding barrel One touch chuckD

Repair(1) Removing Change lever ------------------------------ ------(Page 6 of 14) (2) Install Change lever ------------------------------- ---

•Installing Change lever (same as HR4000C) •Removing Change lever(same as HR4000C)a. Set the change lever at neutral position, and slightly hit

a. Slide down Chuck cover and remove Tool holder cap.(See the figure 4.) b. Remove pan head screws, and then remove Crank housing cover a

¥Disassembling the chuck(See the figure 10.) a. Remove Tool holder cap, Chuck cover and Crank housing cover. b. Remove ring spring 25.

a. Remove Retaining WR-50. To remove Retaining WR-50, use retaining ring plier. b. To disconnect the ball bearing 6910,use gear puller

a. Set the 3 pieces of O ring 36 on Cylinder 40, and insert them into the crank housing. b. Insert the piston until the rod hole is placed inside

a. Set the parts described below into the crank housing.(See the figure 20.) b. To set the spiral bevel gear 41, use the tool holder without mountin