Makita HR2460F Instruction Manual download pdf (Page 5)

Reversing switch action

007935

CAUTION:

• Always check the direction of rotation before

operation.

• Use the reversing switch only after the tool comes

to a complete stop. Changing the direction of

rotation before the tool stops may damage the tool.

• If the switch trigger can not be depressed, check to

see that the reversing switch is fully set to

position

(A side) or (B side).

This tool has a reversing switch to change the direction

of rotation. Move the reversing switch lever to

the

position (A side) for clockwise rotation or

the

position (B side) for counterclockwise rotation.

Selecting the action mode

007936

This tool employs an action mode changing knob. Select

one of the two modes suitable for your work needs by

using this knob.

For rotation only, turn the knob so that the arrow on the

knob points toward the

symbol on the tool body.

For rotation with hammering, turn the knob so that the

arrow on the knob points toward the

symbol on the tool

body.

CAUTION:

• Always set the knob fully to your desired mode

symbol. If you operate the tool with the knob

positioned halfway between the mode symbols, the

tool may be damaged.

• Use the knob after the tool comes to a complete

stop.

Torque limiter

The torque limiter will actuate when a certain torque

level is reached. The motor will disengage from the

output shaft. When this happens, the bit will stop turning.

CAUTION:

• As soon as the torque limiter actuates, switch off

the tool immediately. This will help prevent

premature wear of the tool.

• Bits such as hole saw, which tend to pintch or

catch easily in the hole, are not appropriate for this

tool. This is because they will cause the torque

limiter to actuate too frequently.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the

tool.

Side grip (auxiliary handle)

007937

CAUTION:

• Always use the side grip to ensure operating

safety.

Install the side grip so that the teeth on the grip fit in

between the protrusions on the tool barrel. Then tighten

the grip by turning clockwise at the desired position. It

may be swung 360° so as to be secured at any position.

Bit grease

Coat the bit shank head beforehand with a small amount

of bit grease (about 0.5 - 1 g).

This chuck lubrication assures smooth action and longer

service life.

1. Grip base

2. Side grip

3. Loosen

4. Tighten

5. Teeth

6. Protrusion

1. Action mode

changing knob

1. Reversing

switch lever

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HR2460F Instruction Manual Page 5

Comments to this Manuals

Related products and manuals for Rotary hammers Makita HR2460F