Makita HM0870C Instruction Manual download pdf (Page 7)

010493

The bit can be secured at 12 different angles. To change

the bit angle, slide the change ring forward, then turn the

change ring to change the bit angle. At the desired angle,

slide the change ring back to the original position. The

bit will be secured in place.

NOTE:

• The change ring cannot turn when the bit is not

installed on the tool.

OPERATION

Chipping/Scaling/Demolition

010495

010455

Always use the side grip (auxiliary handle) and firmly

hold the tool by both side grip and switch handle during

operations. Turn the tool on and apply slight pressure on

the tool so that the tool will not bounce around,

uncontrolled. Pressing very hard on the tool will not

increase the efficiency.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection

or maintenance.

Lubrication

CAUTION:

• This servicing should be performed by Makita

Authorized Service Centers only.

This tool requires no hourly or daily lubrication because

it has a grease-packed lubrication system. It should be

lubricated every time the carbon brushes are replaced.

Send the complete tool to Makita Authorized Service

Center for this lubrication service.

010458

Run the tool for several minutes to warm it up. Switch off

and unplug the tool.

Loosen the four screws and remove the handle. Note

that the top screws are different from other screws.

010457

Disconnect the connector by pulling them.

010459

1. Screwdriver

2. Crank cap cover

1. Connector

2. White

3. Black

1. Screws

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita HM0870C Instruction Manual Page 7

Comments to this Manuals

Related products and manuals for Rotary hammers Makita HM0870C