Makita GA5020Y Use and Care Manual download pdf (Page 8)

Installing loop handle (Accessory)

CAUTION:

• Always be sure that the loop handle is installed

securely before operation.

008049

Always install the loop handle on the tool before

operation. Hold the tool's switch handle and the loop

handle firmly with both hands during operation.

Install the loop handle so that its protrusion will fit into

the matching hole in the gear housing.

Install the bolts and tighten them with the hex wrench.

The loop handle can be installed in two different

directions as shown in the figures whichever is

convenient for your work.

008047

008048

Installing or removing wheel guard

CAUTION:

• When using a depressed center grinding

wheel/Multi-disc, wire wheel brush or cut-off wheel,

the wheel guard must be fitted on the tool so that

the closed side of the guard always points toward

the operator.

For tool with locking screw type wheel guard

007994

Mount the wheel guard with the protrusion on the wheel

guard band aligned with the notch on the bearing box.

Then rotate the wheel guard around 180 degrees

counterclockwise. Be sure to tighten the screw securely.

To remove wheel guard, follow the installation procedure

in reverse.

For tool with clamp lever type wheel guard

008343

008344

Loosen the lever on the wheel guard after loosening the

screw. Mount the wheel guard with the protrusion on the

wheel guard band aligned with the notch on the bearing

box. Then rotate the wheel guard around to the position

shown in the figure. Tighten the lever to fasten the wheel

guard. If the lever is too tight or too loose to fasten the

wheel guard, loosen or tighten the screw to adjust the

tightening of the wheel guard band.

To remove wheel guard, follow the installation procedure

in reverse.

1. Screw

1. Bearing box

2. Wheel guard

3. Screw

4. Lever

1. Wheel guard

2. Screw

3. Bearing box

1. Loop handle

2. Hex wrench

3. Bolt

1. Loop handle

2. Hex wrench

3. Bolt

1. Protrusion of

loop handle

2. Matching hole in

gear housing

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita GA5020Y Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Makita GA5020Y