Makita BO5030 Use and Care Manual download pdf (Page 5)

Installing or removing abrasive disc

009102

To install the abrasive disc, first remove all dirt or foreign

matter from the pad. Then peel off the backing paper

from the abrasive disc and attach the abrasive disc to

the pad. Be careful to align the holes in the abrasive disc

with those in the pad.

CAUTION:

• If you peel off the abrasive disc from the pad, its

adhesion will become poor. Never attempt to stick

it onto the pad for further use.

Installing dust bag

009104

Install the dust bag on the tool so that the Makita logo on

the dust bag will be upright (not upside down).

Emptying dust bag

003323

When the dust bag is about half full, switch off and

unplug the tool. Remove the dust bag from the tool.

Then remove the dust nozzle from the dust bag after

unlocking the dust nozzle by turning it slightly

counterclockwise. Empty the dust bag by tapping it

lightly.

After emptying the dust bag, install the dust nozzle on

the dust bag. Turn the dust nozzle slightly clockwise to

lock it in place. Then install the dust bag on the tool as

described in "Installing dust bag".

003326

OPERATION

Sanding operation

009103

CAUTION:

• Never switch on the tool when it is in contact with

the workpiece, it may cause an injury to operator.

• Never run the tool without the abrasive disc. You

may seriously damage the pad.

• Never force the tool. Excessive pressure may

decrease the sanding efficiency, damage the

abrasive disc or shorten tool life.

• Using the tool with the pad edge contacting the

workpiece may damage the pad.

Hold the tool firmly. Turn the tool on and wait until it

attains full speed. Then gently place the tool on the

workpiece surface. Keep the pad flush with the

workpiece and apply slight pressure on the tool.

CAUTION:

• The sanding pad rotates clockwise during the

loaded operation, but it may rotate

counterclockwise during the no-load operation.

MAINTENANCE

CAUTION:

• Always be sure that the tool is switched off and

unplugged before attempting to perform inspection

or maintenance.

1. Dust nozzle

1. Dust bag

1 2 3 4 5 6 7 8 9 10 ... 19 20

Comments to this Manuals

No comments

Makita BO5030 Use and Care Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Makita BO5030