Makita 6908D User Manual download pdf (Page 5)

5. Do not short the battery cartridge:

(1) Do not touch the terminals with any con-

ductive material.

(2) Avoid storing battery cartridge in a con-

tainer with other metal objects such as

nails, coins, etc.

(3) Do not expose battery cartridge to water or

rain.

A battery short can cause a large current flow,

overheating, possible burns and even a break-

down.

6. Do not store the tool and battery cartridge in

locations where the temperature may reach or

exceed 50°C (122°F).

7. Do not incinerate the battery cartridge even if

it is severely damaged or is completely worn

out. The battery cartridge can explode in a fire.

8. Be careful not to drop, shake or strike battery.

9. Do not charge inside a box or container of any

kind. The battery must be placed in a well

ventilated area during charging.

ADDITIONAL SAFETY RULES

FOR TOOL

ENB024-1

1. Be aware that this tool is always in an operat-

ing condition, because it does not have to be

plugged into an electrical outlet.

2. Hold tool by insulated gripping surfaces when

performing an operation where the cutting tool

may contact hidden wiring. Contact with a

‘‘live’’ wire will also make exposed metal parts

of the tool ‘‘live’’ and shock the operator.

3. Always be sure you have a firm footing.

Be sure no one is below when using the tool in

high locations.

4. Hold the tool firmly.

5. Wear ear protectors.

SAVE THESE INSTRUCTIONS.

OPERATING INSTRUCTIONS

Installing or removing battery cartridge

(Fig. 1)

•

Always switch off the tool before insertion or

removal of the battery cartridge.

•

To remove the battery cartridge, withdraw it from the

tool while pressing the buttons on both sides of the

cartridge.

•

To insert the battery cartridge, align the tongue on

the battery cartridge with the groove in the housing

and slip it into place. Always insert it all the way until

it locks in place with a little click. If not, it may

accidentally fall out of the tool, causing injury to you

or someone around you.

•

Do not use force when inserting the battery car-

tridge. If the cartridge does not slide in easily, it is

not being inserted correctly.

Charging (Fig. 2)

Your new battery cartridge is not charged. You will need to charge it before use. Use the fast charger Model

DC1411 to charge the battery cartridge.

Plug the fast charger into the proper AC voltage source. The charging light will flash in green color. Insert the

battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their

respective markings on the fast charger. Insert the cartridge fully into the port so that it rests on the charger port

floor. When the battery cartridge is inserted, the charging light color will change from green to red and charging

will begin. The charging light will remain lit steadily during charging. When the charging light color changes from

red to green, the charging cycle is complete. If you leave the battery cartridge in the charger after the charging

cycle is complete, the charger will switch into its ‘‘trickle charge (maintenance charge)’’ mode which will last

approximately 24 hours. After charging, unplug the charger from the power source. Refer to the table below for

the charging time.

Battery type Capacity (mAh) Number of cells

Charging time with

fast charger DC1411

9122 2,000 8 Approx. 60 min.

9133 2,200 8 Approx. 65 min.

9134 2,600 8 Approx. 75 min.

9135 3,000 8 Approx. 90 min.

CAUTION:

•

The fast charger Model DC1411 is for charging Makita battery cartridge. Never use it for other purposes or

for other manufacturer’s batteries.

•

When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of

time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can

recharge the battery cartridge fully after discharging it completely and recharging a couple of times.

6908D (E) (’100. 9. 26)

1 2 3 4 5 6 7 8 9 10 ... 63 64

Comments to this Manuals

No comments

Makita 6908D User Manual Page 5

Comments to this Manuals

Related products and manuals for Power tools Makita 6908D