Chain Saw MODEL 501 4NB 501 6N8 340 mm (13-3/8") MODEL 5014NB 375 mm (14-3/4") MODEL 5016NB Overall Net Chain speed Length of Saw chain P
Lubrication This tool is equipped with an automatic lubrication system, so the chain is lubricated automatically when the motor is running. I Gear
Hook When using an extension cord, secure it to the tool’s cord with the hook provided. Attach the hook about 100-200 mm (4”- 8”) from the ext
To release the chain brake, reset the pro- tector to the exact original position after turning the tool off. Fig. 14 WARNING: 0 Under norm
Using the chain saw Always be sure of your footing and hold the chain saw firmly with both hands while the motor is running. Felling a tree When
Felling back cut Limbing a tree Limbing is removing the branches from a fallen tree. When limbing, leave larger lower limbs to support the l
Bucking a log Bucking is cutting a log into lengths. It is important to make sure your footing is firm and your weight is evenly distributed on bo
When bucking on a slope, always stand on the uphill side of the log, as shown in Fig. 22. When ”cutting through”, to maintain complete control,
MAINTENANCE CAUTION : Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Filling sa
Removing chip buildup Chips and sawdust will build up in the guide bar groove and oil hole, clogging them and impairing oil flow. Remove the guide
ACCESSORIES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of an
IMPORTANT SAFETY INSTRUCTIONS WARNING: WHEN USING AN ELECTRIC CHAIN SAW, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIR
Aq-25438 US CHAIN SAW 340 mm (13-318") Model 5014NB 375 mm (14-3/47 Model 5016NB Note: The switch, noise suppressor and other part configurat
MODEL 5014NB 5016NB $:D DESCRIPTION 54 55 56 57 58 59 60 61 62 63 Aug - 25-'88 US $tD DESCRIPTION 1 6 1 I 1 2 1 2 1 1 lo 1 11 1 :: 1 ; 14 1 15 1
MAKllA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to
9. Use Safety Glasses Also use safety footwear; snug fitting clothing; protective gloves; hearing and head protection. Carry the chain saw by the f
(1) Grip saw firmly. Hold the chain saw firmly with both hands when the motor is running. Use a firm grip with thumbs and fingers encircling the chai
Use Of Extension Cord If the extension cord is intended to be used outdoors, the cord shall be marked with the suffix W-A following the cord type des
Chain Saw Nomenclature LEFT SIDE Front handle v RIGHT Rear handle / Trigger switch SIDE Oil cap Guide bar nose \ I Guide bar mounting pad Sprocket
Front Handle Guard - A structural barrier between the front handle of a chain saw and the guide bar, typically located close to the hand position on t
Installing saw chain and guide bar CAUTION : Always be sure that the tool is switched off and unplugged before installing saw chain and guide bar Us
Adjusting saw chain tension CAUTION : Always be sure that the tool is switched off and unplugged before adjusting chain tension. Grasp the chain in
Comments to this Manuals