Makita DPC7321 User Manual download pdf (Page 20)

Adjusting

the carburetor

NOTE: The grinding parts are equipped with an electronic

ignition to limit the speed.

At the factory the idling speed has been set to approx.

2500 rpm, but the running-in process of a new engine may

require slight readjustment of the idling speed.

For correct adjustment of the idling speed the following

steps must be carried out:

Start the engine and run it until it is warm (about 3 - 5

minutes).

Adjust the carburetor with the screwdriver (1, Order No. 944

340 001) included with the Power Cut. It has a lug that helps

with adjustment.

Readjust the idling speed.

If the cut-off disc is still turning when the engine is running,

unscrew the adjusting screw of the throttle valve (2) until the

cut-off disc is no longer turning. When the engine is left running

at idling speed, loosen the screw a little.

Switch off the engine

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

No comments

Makita DPC7321 User Manual Page 20