Makita 4326 Instruction Manual download pdf (Page 8)

008089

Tilt the base until the desired bevel angle is obtained.

The edge of the motor housing indicates the bevel angle

by graduations. Then tighten the bolt to secure the base.

008090

Front flush cuts

008091

Loosen the bolt on the back of the base with the hex

wrench and slide the base all the way back. Then tighten

the bolt to secure the base.

Cutouts

Cutouts can be made with either of two methods A or B.

A) Boring a starting hole

008092

For internal cutouts without a lead-in cut from an

edge, pre-drill a starting hole 12 mm or more in

diameter. Insert the blade into this hole to start your

cut.

B) Plunge cutting

008093

You need not bore a starting hole or make a lead-in

cut if you carefully do as follows.

(1) Tilt the tool up on the front edge of the base

with the blade point positioned just above the

workpiece surface.

(2) Apply pressure to the tool so that the front

edge of the base will not move when you

switch on the tool and gently lower the back

end of the tool slowly.

(3) As the blade pierces the workpiece, slowly

lower the base of the tool down onto the

workpiece surface.

(4) Complete the cut in the normal manner.

Finishing edges

008094

To trim edges or make dimensional adjustments, run the

blade lightly along the cut edges.

Metal cutting

Always use a suitable coolant (cutting oil) when cutting

metal. Failure to do so will cause significant blade wear.

The underside of the workpiece can be greased instead

of using a coolant.

1. Starting hole

1. Hex wrench

2. Bolt

3. Base

1. Edge

2. Graduation

1. Hex wrench

2. Bolt

3. Base

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Makita 4326 Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Cordless jigsaws Makita 4326