Makita 3606 Specifications Page 1

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comR

10Install the trimmer guide on the tool base with the wing bolt(B). Loosen the wing bolt (A) and adjust the distancebetween the bit and the trimmer gu

11ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other acc

Memo12

13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

35.Avoid body contact with grounded sur-faces such as pipes, radiators, ranges andrefrigerators. There is an increased risk ofelectric shock if your b

4SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcould result in

59.Before using the tool on an actual work-piece, let it run for a while. Watch forvibration or wobbling that could indicateimproperly installed bit.1

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Adjusting

7To start the tool, move the switch lever to the I (ON) position.To stop the tool, move the switch lever to the O (OFF) posi-tion.ASSEMBLYCAUTION:• Al

8NOTE:• Moving the tool forward too fast may cause a poorquality of cut, or damage to the bit or motor. Moving thetool forward too slowly may burn and

9Templet guide (optional accessory)The templet guide provides a sleeve through which the bitpasses, allowing use of the tool with templet patterns.To