Makita GA5040X1 Use and Care Manual download pdf (Page 7)

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and

unplugged before adjusting or checking function on

the tool.

Shaft lock

012725

CAUTION:

• Never actuate the shaft lock when the spindle is

moving. The tool may be damaged.

Press the shaft lock to prevent spindle rotation when

installing or removing accessories.

Switch action

012728

CAUTION:

• Before plugging in the tool, always check to see

that the slide switch actuates properly and returns

to the "OFF" position when the rear of the slide

switch is depressed.

• Switch can be locked in "ON" position for ease of

operator comfort during extended use. Apply

caution when locking tool in "ON" position and

maintain firm grasp on tool.

To start the tool, slide the slide switch toward the "I (ON)"

position by pushing the rear of the slide switch. For

continuous operation, press the front of the slide switch

to lock it.

To stop the tool, press the rear of the slide switch, then

slide it toward the "O (OFF)" position.

ASSEMBLY

CAUTION:

• Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Installing side grip (handle)

012724

CAUTION:

• Always be sure that the side grip is installed

securely before operation.

Screw the side grip securely on the position of the tool as

shown in the figure.

Installing or removing wheel guard (For

depressed center wheel, multi-disc, flex wheel,

wire wheel brush / abrasive cut-off wheel,

diamond wheel)

WARNING:

• When using a depressed center wheel, multi-disc,

flex wheel or wire wheel brush, the wheel guard

must be fitted on the tool so that the closed side of

the guard always points toward the operator.

• When using an abrasive cut-off / diamond wheel,

be sure to use only the special wheel guard

designed for use with cut-off wheels.

For tool with locking screw type wheel guard

012733

Mount the wheel guard with the protrusions on the wheel

guard band aligned with the notches on the bearing box.

Then rotate the wheel guard around 180 ﾟ

counterclockwise. Be sure to tighten the screw securely.

To remove wheel guard, follow the installation procedure

in reverse.

1. Wheel guard

2. Bearing box

3. Screw

1. Slide switch

1. Shaft lock

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comments to this Manuals

No comments

Makita GA5040X1 Use and Care Manual Page 7

Comments to this Manuals

Related products and manuals for Angle grinders Makita GA5040X1