Angle Grinder Overall length No load speed (RPM) 180 mm (7”) MODEL 90471. 230 mm (9”) MODEL 9049 INSTRUCTION MANUAL Net weight Spindle thread DOUBLE
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other acc
@Rubber pad Part No. 743012-7 741 41 5-A @Sanding lock nut 48 (For abrasive disc) Part No. 22451 7-1 A24R 9" x 114" x 518" 9049 @Wir
No".-01 -'96 US ANGLE GRINDER 180 mm (7") Model 9047L 230 mm (9") Model 9049 Note: The switch and other part configurations may d
MODEL 9047L, 9049 Nov.-01-'96 US IFOM DESCRIPTION '2: DESCRIPTION MACHINE 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 1
MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted t
GENERAL SAFETY RULES (For All Tools) WARNING! Read and understand all instructions. Failure to follow all instructions listed below, may result in el
11. Avoid accidental starting. Be sure switch is off before plugging in. Carrying tools with your finger on the switch or plugging in tools that have
Specific Safety Rules 1. Always use proper guard with grinding wheel. A guard protects operator from broken wheel fragments. 2. Accessories must be ra
SYMBOLS The followings show the symbols used for tool. ... volts ... amperes ...
Installing wheel guard When using a depressed center wheel or an abrasive cut-off wheel, always use a wheel guard. Mount the wheel guard with the tab
Installing or removing depressed center wheel CAUTION: Always be sure that the tool is switched off and unplugged before installing or removing the w
Operation Hold the tool firmly. Turn the tool on and then apply the wheel or disc to the workpiece. In general, keep the edge of the wheel or disc a
MAINTENANCE CAUTl ON: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Replacing ca
Comments to this Manuals