INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comC
10To install the blade, follow the removal procedure in reverse.BE SURE TO TIGHTEN THE HEX BOLT COUNTER-CLOCKWISE SECURELY.When changing blade, make s
11Rip fence (Guide rule)The handy rip fence allows you to do extra-accurate straightcuts. Simply slide the rip fence up snugly against the side ofthe
12ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other acc
13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut
141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )
15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSALABAMA2365 Pelham ParkwayPelham, AL 35124 (205) 620-1791ARIZONA3707 E. Bro
WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif
2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S
3change the plug in any way. Double insula-tion eliminates the need for the three wiregrounded power cord and grounded powersupply system.5. Avoid b
4SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcould result in
5does not touch the blade or any other part, inall angles and depths of cut.To check lower guard, open lower guard byhand, then release and watch guar
6Support large panels to minimize the riskof blade pinching and KICKBACK. Largepanels tend to sag under their own weight.Supports must be placed under
7firmly to prevent loss of control whichcould cause personal injury. Fig. 4 illus-trates typical hand support of the saw.16. Place the wider portion o
8FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Adjusting
9Switch actionCAUTION:• Before plugging in the tool, always check to see that theswitch trigger actuates properly and returns to the “OFF”position whe
Comments to this Manuals